Autostart as2520 Guia de Instalação

Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either da

The Programming Assistance Button (A.k.a. the PAB.) Mounted on the module, this button can be used from within the vehicle instead of the hood pin

Installation Guide P. 11 1. Flash the hood pin switch (see page 9) – The parking lights will stay ON for up to 20 seconds. – Before the lights go

P. 12 Installation Guide Please note that the different functions within any particular mode can only be accessed sequentially: the programming ce

Installation Guide P. 13 Example: If the multi-level features were set to option 3, the setup would be as follows: x Level 1 Æ Customized featu

P. 14 Installation Guide 4. Press the brake pedal and keep it down until you see the parking lights flash 5 times (If the horn is configured, you

Installation Guide P. 15 Testing Before putting back the vehicle together, it is recommended to check that the system operates properly. The follow

P. 16 Installation Guide Caution! Only one set of pins can be used at one time. Using more than one jumper may result in serious damage to the ve

Installation Guide P. 17 Priority Door This feature allows to unlock the driver’s door by pressing UNLOCK once and to unlock all other doors by pre

P. 18 Installation Guide Resetting the module is not a required process. Most of the time, you can avoid resetting by fixing the issue directly a

Installation Guide P. 19 Diagnostics – Parking Light Flash Table Flashes Description 1 • Doors locked, starter kill armed. • End of run time. •

P. 2 Installation Guide Table of Contents Introduction ...2 Included in the Kit ...

Programming Options MODE 1 * INDICATES DEFAULT SETTING FUNCTION 1 – Ignition-controlled door locks OPTION 1* Ignition lock DISABLED OPTION 2 Igniti

AS-2520TW Programming Options and Wiring Diagram

Installation Guide P. 3 INDUSTRY CANADA USER NOTICE: Operation is subject to the following two conditions: (1) this device may not cause interfere

P. 4 Installation Guide Wiring a clutch bypass and a transponder module to the GROUND OUT WHEN RUNNING wire: At the junction point, where the GR

Installation Guide P. 5 This wire will power the heater blower motor. Usually connected to the accessories wire of the vehicle. The source wire mus

P. 6 Installation Guide 12-Pin Accessories Harness Wire Colour Function Description 1 BLUE (–) Trunk / AUX 3 output 500 mA negative output. Th

Installation Guide P. 7 9 PURPLE (–) External Trigger The external trigger wire can be used for remote-starting the vehicle with an external devic

P. 8 Installation Guide 12 YELLOW (+) Glow-Plug input In diesel mode, this positive input will monitor the glow plug light: it will wait for up t

Installation Guide P. 9 2-Pin Harness Wire Colour Function Description 1 BLUE/ WHITE (–) N/A This pin is not used. Leave it empty. 2 YELLOW (–